From:Jim Garrett e-mail:patjim-A-sacoriver.net
Subject:RE: RE: 54 165 ST Wiring Harness Date:Thu Jun 21 13:47:22 2012
Response to:17518
Gene,

I should have included this in my 1st post. The overall length of the black wire from where it attaches to the coil to the back end, eyelet center to eyelet center, is 22". Hope this helps. jim

----- ORIGINAL MESSAGE FOLLOWS -----
Gene,

There are no black wires to the regulator. There should be 2 wires from that harness that go to the rear fender terminals, a black and a green wire. They should be approximately the same length at the back end when the other ends are connected to the switch and the coil. Do you have a wiring diagram? The hookup should be illustrated on it. jim Garrett

----- ORIGINAL MESSAGE FOLLOWS -----
In my new harness there is a black wire that is coming from the ignition going to a terminal screw on the front of the rear fender.
Every pre-cut wire in the harness is perfect except this one is too short. However it will reach some point on the voltage regulator, QUESTION; Is there a point on the regulator that this can go to ??