From:CJ e-mail:Mathsci-A-hotmail.com
Subject:RE: cylinder ball hone Date:Sun Jan 12 18:41:59 2014
Response to:19162
Hi Nuk147, you might want to take a look at this site-

http://www.everything2stroke.com/content/21-Cylinder-Honing-
Do%E2%80%99s-Don%E2%80%99ts

The guy who wrote the post appears to have been a machinist since gods
dog was a pup and has some decided ideas about what hones should ne
used when.




----- ORIGINAL MESSAGE FOLLOWS -----
HELLO, I AM LOOKING TO BUY A BALL CYLINDER HONE FOR CROSS
HATCH. MY CYLINDER IS AT 2.385 AND .20 OVER. WILL A HONE 2.400-
2.550 BE ALL RIGHT? ALSO WHAT GRIT? THANK YOU FOR YOUR
TIME AND PATIENCE.