From:Jack e-mail:jholhate-A-bellsouth.net
Subject:RE: RE: RE: RE: Speedometer Cable Date:Mon Nov 28 15:28:15 2016
Response to:21594
Where did you find the speedo gears/parts?
Jack
62 Pacer
----- ORIGINAL MESSAGE FOLLOWS -----
Thanks for the input guys. I was able to get the plug out. Turns out the
gears
were installed wrong. Gear drive was destroyed. I have new parts on
order. I'll be
pulling wheel apart to replace the speedo gears and reinstall the cable
and gear
drive. Pic attached... pretty munched!

----- ORIGINAL MESSAGE FOLLOWS -----

The "Plug" on the wheel end of the speedometer cable is held in place by
the drive
gear bushing screw (PN67110-49)
If you have removed that screw, then B-Y-Bob's info is the correct
procedure. If
you have not removed that screw, the cable plug will not come out
without
destroying the front
brake side plate, ( PN4144-51 )

Duane Taylor




----- ORIGINAL MESSAGE FOLLOWS -----
Heat yes...and 'Blaster' (NAPA auto). Wrap a cloth around
it and wiggle it with channel lock pliers.

----- ORIGINAL MESSAGE FOLLOWS -----
I have a 1960 Super 10. Everything works great on the bike
except for the speedo. I had the speedo restored and I've
tested it. It works. The problem, I believe, is in the
wheel. Problem is I can't get the darn plug at the end of
the speedo cable to come out. It's stuck in there. It
comes out about an 1/8 of an inch maybe and then won't
budge. Any ideas? I've tried some lube around the hole
but that didn't do it. Should I apply some heat? Should I
emery cloth the plug before re-installing next time? BTW I
can remove the inner speedo cable... I'm thinking either a
gear broke or the cable broke at the end.

Sent from IP Address: 99.184.174.153
Lookup 99.184.174.153

Reverse Telephone Lookup