From:CJ e-mail:mathsci-A-hotmail.com
Subject:RE: Ignition Date:Sat Aug 12 20:46:16 2017
Response to:22215
You might want to check here for wiring diagrams - http://www.harleyhummerclub.org/restore/chapter66/

Also, seem to remember reading that the magneto systems may need to be re-magnetized and think that Mutt has the knowledge and equipment to do the job. Finally, might be worth your time to make sure that the point contacts are clean... a little glaze might stop the whole show. Some fine emery paper would help with that.

----- ORIGINAL MESSAGE FOLLOWS -----
Ok, I'm here.
I've got power, but no spark. I'm ready to just buy all new parts, but I thought one of you would be able to ask me to help me walk through this simple electrical system. I probably need a new plug,coil and points, but can find no wire diagram to see if it even hooked correctly. I've got the horn to beep, and the headlight has power, but the bulbs burned, the taillight works, but I'm not getting a spark, and this is where I fall short. Not the best with electrical systems. I feel like this should be a no brained, but without a schematic, or the understanding of the magneto and regulator, I'm thinking I should reach out for help. Let me know what you think.
And seriously, Thanks.

Sent from IP Address: 68.116.107.131
Lookup 68.116.107.131

Reverse Telephone Lookup