From:Mario e-mail:mariol.vitale-A-att.net
Subject:RE: Starter sector gear Date:Mon Aug 14 13:50:21 2017
Response to:22213

Joep,
It looks to me like the sector could be re-built by
building up the worn teeth with weld and re-machining
them, using the pristine teeth on the other end of the
sector to index the machining of the built up areas.
Obviously you would need a milling machine or possibly a
lathe, to do this. It is not unheard of for gear teeth
like this to be hand filed! :)

Another thought comes to mind... How is the sector
attached to the shaft? If it could be removed, it might
be possible to reverse it so the good section is where
the contact is made.

Mario
----- ORIGINAL MESSAGE FOLLOWS -----
I got two of these and they both look the same

I was told good ones are hard to find, but maybe someone
knows where to get a descent one. Or do you guys repair
these ?

thanks
Joep

Sent from IP Address: 157.191.82.10
Lookup 157.191.82.10

Reverse Telephone Lookup