From:Adam Wagner e-mail:adamwagner07-A-gmail.com
Subject:RE: RE: Bearing Question Date:Sun Oct 29 21:20:07 2017
Response to:22342
Hi Mutt

This bearing was sealed on both sides. Which side needs
to the plastic removed or should I just remove both sides?
I was taken back by how easy they went in considering the
challenges I had getting them out!


----- ORIGINAL MESSAGE FOLLOWS -----
You have the seal in backwards. The 9012 bearing should
only
be sealed on one side.It's actually a bad idea anyway,
because the seal will end up running dry. The bearings
should
be a light press fit. Never heard of an oversize bearing,
but
that would be nice if they did.

----- ORIGINAL MESSAGE FOLLOWS -----
I'm reassembling the cases for my 63 Scat. The oil seal
that goes into the bearing retainer looks very different
than
the original. Pics posted of front n back of that bearing.
I
tried to match the orientation with that of the original.
Also, The magneto shaft bearing (part 9012) is sealed on
both
sides. Is this correct? It also fit pretty loose in that
case. Wondering if I need an oversized bearing.

As always, thanks for your help.

Sent from IP Address: 73.26.108.46
Lookup 73.26.108.46

Reverse Telephone Lookup