From:Mutt e-mail:pigstye13-A-aol.com
Subject:RE: transmission reassembly Date:Fri Dec 1 21:10:44 2017
Response to:22392
Close the cases up with teh shifter and complete
transmission. install 3 or 4 case screws. Install the
kicker cover and kicker shaft and the 3 rear screws and then
the shifter lever. You will need to turn the main drive gear
sprocket while shifting thru the gears, or you will only find
usually first and neutral

----- ORIGINAL MESSAGE FOLLOWS -----
I'm reassembling the transmission and everything goes
together just fine up until the step where the manual says to
shift through the gears several times before moving on. Mine
does not. Seems to be stuck at the ball retainer which is
not stuck. Everything moves freely until I put it together.
Gears and bearings turn just fine but the pawl does not move
very much. Not sure what to expect here. Should I be able
to manipulate the transmission through the gears manually by
hand easily?

Thanks

Sent from IP Address: 12.87.28.130
Lookup 12.87.28.130

Reverse Telephone Lookup