From:Gene e-mail:gmdrafter-A-gmail.com
Subject:RE: RE: RE: 54 165 ST Wiring Harness Date:Thu Jun 21 23:13:04 2012
Response to:17519

Thanks guys, your the best.
----- ORIGINAL MESSAGE FOLLOWS -----
Gene,

I should have included this in my 1st post. The overall
length of the black wire from where it attaches to the coil
to the back end, eyelet center to eyelet center, is 22".
Hope this helps. jim

----- ORIGINAL MESSAGE FOLLOWS -----
Gene,

There are no black wires to the regulator. There should be 2
wires from that harness that go to the rear fender
terminals, a black and a green wire. They should be
approximately the same length at the back end when the other
ends are connected to the switch and the coil. Do you have a
wiring diagram? The hookup should be illustrated on it. jim
Garrett

----- ORIGINAL MESSAGE FOLLOWS -----
In my new harness there is a black wire that is
coming from the ignition going to a terminal screw on the
front of the rear fender.
Every pre-cut wire in the harness is perfect except this one
is too short. However it will reach some point on the
voltage regulator, QUESTION; Is there a point on the
regulator that this can go to ??