From: | Backyard Bob | e-mail: | somewhere-A-nj |
Subject: | RE: RE: RE: Rod Bearings | Date: | Wed Nov 5 19:39:25 2014 |
Response to: | 19977 |
As a machinist and a bike enthusiast I think you're seeking the Holy Grail here in trying to 'tighten it up a bit'. You're within tolerances and should spend your time, money and effort elsewhere. You're good. HOWEVER.... I will go to bended knee if Mutt disagrees. ----- ORIGINAL MESSAGE FOLLOWS ----- Thank you for the quick reply. My machine is a 63 Scat and the pins measure .121" It has been apart before, someone really tore the plates up. The rod and crank pin look good, I think .122" pins would tighten it up. Does anyone sell these oversize rollers. Thanks again, Scott ----- ORIGINAL MESSAGE FOLLOWS ----- depends on what year/ 48-60 models use .250" x .490 long 61 to 66 use .120" diameter needles ----- ORIGINAL MESSAGE FOLLOWS ----- Can someone please tell me what the stock dimension is for the crank pin roller bearings? Thanks, Scott |