From:Duane Taylor e-mail:duane-A-taylorclassiccycles.com
Subject:RE: RE: RE: RE: '62 Pacer Toolbox Date:Thu Mar 30 11:35:08 2017
Response to:21870

RE 61-62 Tool box. I have many (useless/rusted) original tool boxes but have never seen a 64202-61. When I reproduced the tool box I did not know there was a variant and would like to see one or good pictures of the "dent" and extra hole.
Of interest (at least to me):
The original tool box lid (at the open end ) did not fit well, binding on the box on closure. The problem and fix was obvious but HD never changed it for reasons unknown ??

Duane Taylor







----- ORIGINAL MESSAGE FOLLOWS -----
I just happen to have a NOS one around here somewhere. I can dig it out and take a photo if desired.

Mutt is correct - there's an extra hole on the back. If I remember correctly, there's a little "dent" in the back, so the extra hole is at an angle. Not 100% sure, though.

The 1955-1959 Hummers, and 1960-62 bikes did not have the toolbox mounting bracket on the frame, so a little U-shaped bracket is required to slip over the frame. Not sure if these were included with the toolbox or sold separately.

Dave


----- ORIGINAL MESSAGE FOLLOWS -----

Also the 61-62 BT models have a special tool box. It as 2
holes in the back for mounting, instead of one on all the
other models, due to the 16" wheels. Very hard to find in
any condition



----- ORIGINAL MESSAGE FOLLOWS -----
Tools boxes were an accessory on 55-62 B BT BTH BTF
models

----- ORIGINAL MESSAGE FOLLOWS -----
Just curious if the '62 Pacer came with a toolbox like the
165's, if a toolbox was an option, or if the Pacer had
something else (like a tool roll).

I have looked at a lot of pictures and have not been able
to
tell from what I found.

Thanks for any assistance

Sent from IP Address: 75.164.136.159
Lookup 75.164.136.159

Reverse Telephone Lookup