From: | backyard bob | e-mail: | somewhere-A-new jersey |
Subject: | RE: RE: transmission reassembly | Date: | Fri Dec 1 22:57:58 2017 |
Response to: | 22394 |
You are da man Mutt. ----- ORIGINAL MESSAGE FOLLOWS ----- Close the cases up with teh shifter and complete transmission. install 3 or 4 case screws. Install the kicker cover and kicker shaft and the 3 rear screws and then the shifter lever. You will need to turn the main drive gear sprocket while shifting thru the gears, or you will only find usually first and neutral ----- ORIGINAL MESSAGE FOLLOWS ----- I'm reassembling the transmission and everything goes together just fine up until the step where the manual says to shift through the gears several times before moving on. Mine does not. Seems to be stuck at the ball retainer which is not stuck. Everything moves freely until I put it together. Gears and bearings turn just fine but the pawl does not move very much. Not sure what to expect here. Should I be able to manipulate the transmission through the gears manually by hand easily? Thanks |
Sent from IP Address: 184.6.210.85
Lookup 184.6.210.85
Reverse Telephone Lookup